Removing Particle Emitters

Removing Particle Emitters

How can I remove particle emitters from models?

u dl magos model editor from this site, open it and then open geoset manager, then hold ctrl and select the particle emitter, in the manager u will c u selected a part now, just delete it and its gone

I tried using Magos Model Editor once, but it turned up as a grey screen every time, and when i tried to get it a different place, it turned up as a corrupt file.

and i need to remove some particle emitters from a model i am making, so is there any other program that can remove particle emitters?

then let me know

i heared some1 had that problem before, it Should be a gray square though, but with a line with file and stuff. try dling the right combgl32 or storm.ddl or whatever it needs

or try using oinkerwinkle tools (oinkerwinkle(tools).com) i dunno how it works there though, never used it

i heared some1 had that problem before, it Should be a gray square though, but with a line with file and stuff. try dling the right combgl32 or storm.ddl or whatever it needs

or try using oinkerwinkle tools (oinkerwinkle(tools).com) i dunno how it works there though, never used it

yea, a grey square, that's all i get from the model editor, and i don't know wich one of oinkerwinkle's tools that does the particle removing, so do you know wich oinkerwinkle tool that does particle removing, or what file that is needed to run Magos Model Editor?

it shows u what u ned to dl when u start it and gives error, if it doesnt show i dint know

for removing the particle emitters i think u need vertex modifier, i dont know for sure i dont work with oinkeriwnkle

If you need to get rid of particles, and are just lazy, I normally just go and set their emission rate to 0

Doesn't "remove" them persay, but does stop them from showing

MecheonIf you need to get rid of particles, and are just lazy, I normally just go and set their emission rate to 0

Doesn't "remove" them persay, but does stop them from showing

and what i need to do that

Notepad and WC3 File Converter

not that ive the problem, but to make iteasier for him u should change the mdx to mdl and open the mdl with note pad or word pad, then find the particel emitter info and set that to 0 right?